TEC Monitor Software

Version 2-1-3 1.8MB
After downloading, unzip the file and run setup.exe to install the software.

TEC Monitor is a Windows based software tool used to calibrate and monitor Thermo-Electric Chargers (TEC). A diagnostics cable is required to provide the interface between the TEC and your PC's RS232 serial port (USB to RS232 adapter cable is also available). TEC's purchased with the 'D' option provide a connector on the bottom of the unit allowing connection of the diagnostics cable without removing the cover. All TEC's include the SA diagnostics port on the controller. Monitor TE module output, charger setpoint, charger mode, battery voltage, battery temperature and more. Simplifies field troubleshooting and provides easy calibration of measured parameters.

Program Download Utility (PDU)

PDU Manual (PDF) PDU is used to update the firmware in equipment with the 7-pin SA-Port. As new software features are developed for your TEC they can be easily downloaded directly to your device in the field. A key cable, used with the SA diagnostics able, enables programming mode and provides the communications link to your PC. Download the manual for hardware requirements. Your controller must be at software version 6 or higher to use the PDU utility. Use TEC monitor or the SA-216 to check the current software version.

TEC Controller Updates

To download file please right click on the file name below that you wish to download. Select Save Target As. Change Save As Type to "all files" and change extension from .txt to .PGI. For example: rename file to TEC-R8-12V.PGI

Version 8 for 12 Volt TEC (TEC-R8-12V.txt)

Version 8 for 24 Volt TEC (TEC-R8-24V.txt)

Version 7 for 12 Volt TEC (TEC-R7-12V.txt)

Version 7 for 24 Volt TEC (TEC-R7-24V.txt)

Version 6 for 12 Volt TEC (TEC-R7-12V.txt)

Version 6 for 24 Volt TEC (TEC-R7-24V.txt)